Test Programs — Details
The STM32H735-DISCO platform HAL contains some test programs which allow various aspects of the board to be tested.
There are two tests for the ADC, which may be built by enabling
The adc1 test reads the
Vrefint ADC reference voltage,
Vsense internal temperature, and
Vbat battery voltage from channels 16, 17
and 18 of ADC3. These are printed out whenever any changes
by a significant amount.
The adc2 test reads the same sensors as adc1 and in addition reads channel 10 of ADC1, which is connected to the A0 pin of Arduino connector CN9. A potentiometer attached to this pin allows various tests of the ADC system to be performed as prompted by the test itself.
|2021-09-02||eCosPro Non-Commercial Public License|