section:[base + index*scale + disp]
is translated into the AT&T syntax
section:disp(base, index, scale)
where base and index are the optional 32-bit base and
index registers, disp is the optional displacement, and
scale, taking the values 1, 2, 4, and 8, multiplies index
to calculate the address of the operand. If no scale is
specified, scale is taken to be 1. section specifies the
optional section register for the memory operand, and may override the
default section register (see a 80386 manual for section register
defaults). Note that section overrides in AT&T syntax must
be preceded by a ‘%’. If you specify a section override which
coincides with the default section register,
as does not
output any section register override prefixes to assemble the given
instruction. Thus, section overrides can be specified to emphasize which
section register is used for a given memory operand.
Here are some examples of Intel and AT&T style memory references:
Absolute (as opposed to PC relative) call and jump operands must be
prefixed with ‘*’. If no ‘*’ is specified,
always chooses PC relative addressing for jump/call labels.
Any instruction that has a memory operand, but no register operand, must specify its size (byte, word, long, or quadruple) with an instruction mnemonic suffix (‘b’, ‘w’, ‘l’ or ‘q’, respectively).
The x86-64 architecture adds an RIP (instruction pointer relative) addressing. This addressing mode is specified by using ‘rip’ as a base register. Only constant offsets are valid. For example:
symbolin RIP relative way, this is shorter than the default absolute addressing.
Other addressing modes remain unchanged in x86-64 architecture, except registers used are 64-bit instead of 32-bit.