Part LXXIII. RedBoot User's Guide
Prev   Next

Part LXXIII. RedBoot User's Guide

Copyright © 1998-2007, 2009 Free Software Foundation, Inc.

Copyright © 2004-2006, 2014, 2016, 2017 eCosCentric Limited

Documentation licensing terms
Trademarks
Warranty

Table of Contents

228. Getting Started with RedBoot
228.1. More information about RedBoot on the web
228.2. Installing RedBoot
228.3. User Interface
228.4. RedBoot Editing Commands
228.5. RedBoot Command History
228.6. RedBoot Startup Mode
228.7. RedBoot Resource Usage
228.7.1. Flash Resources
228.7.2. RAM Resources
228.8. Configuring the RedBoot Environment
228.8.1. Target Network Configuration
228.8.2. Host Network Configuration
228.8.3. Verification
229. RedBoot Commands and Examples
229.1. Introduction
229.2. Common Commands
229.3. Flash Image System (FIS)
229.4. Filesystem Interface
229.5. Persistent State Flash-based Configuration and Control
229.6. Persistent State in a NAND-based environment
229.6.1. Manipulating persistent state stored on NAND
229.7. Executing Programs from RedBoot
229.8. NAND configuration commands
229.9. NAND manipulation commands
230. Rebuilding RedBoot
230.1. Introduction
230.2. Variables
230.3. Building RedBoot using ecosconfig
230.4. Rebuilding RedBoot from the eCos Configuration Tool
231. Updating RedBoot
231.1. Introduction
231.2. Load and start a RedBoot RAM instance
231.3. Update the primary RedBoot flash image
231.4. Reboot; run the new RedBoot image
232. Initial Installation
232.1. Hardware Installation
232.1.1. What to Expect
Prev   Next
Chapter 227. Configuration Home Chapter 228. Getting Started with RedBoot