Part LXXIII. RedBoot User's Guide
Prev   Next

Part LXXIII. RedBoot User's Guide

Copyright © 1998-2007, 2009 Free Software Foundation, Inc.

Copyright © 2004-2006, 2014, 2016, 2017 eCosCentric Limited

Documentation licensing terms
Trademarks
Warranty

Table of Contents

229. Getting Started with RedBoot
229.1. More information about RedBoot on the web
229.2. Installing RedBoot
229.3. User Interface
229.4. RedBoot Editing Commands
229.5. RedBoot Command History
229.6. RedBoot Startup Mode
229.7. RedBoot Resource Usage
229.7.1. Flash Resources
229.7.2. RAM Resources
229.8. Configuring the RedBoot Environment
229.8.1. Target Network Configuration
229.8.2. Host Network Configuration
229.8.3. Verification
230. RedBoot Commands and Examples
230.1. Introduction
230.2. Common Commands
230.3. Flash Image System (FIS)
230.4. Filesystem Interface
230.5. Persistent State Flash-based Configuration and Control
230.6. Persistent State in a NAND-based environment
230.6.1. Manipulating persistent state stored on NAND
230.7. Executing Programs from RedBoot
230.8. NAND configuration commands
230.9. NAND manipulation commands
231. Rebuilding RedBoot
231.1. Introduction
231.2. Variables
231.3. Building RedBoot using ecosconfig
231.4. Rebuilding RedBoot from the eCos Configuration Tool
232. Updating RedBoot
232.1. Introduction
232.2. Load and start a RedBoot RAM instance
232.3. Update the primary RedBoot flash image
232.4. Reboot; run the new RedBoot image
233. Initial Installation
233.1. Hardware Installation
233.1.1. What to Expect
Prev   Next
Chapter 228. Configuration Home Chapter 229. Getting Started with RedBoot