Debugging with GDB: Background Execution

---

5.5.3 Background Execution

GDB’s execution commands have two variants: the normal foreground (synchronous) behavior, and a background (asynchronous) behavior. In foreground execution, GDB waits for the program to report that some thread has stopped before prompting for another command. In background execution, GDB immediately gives a command prompt so that you can issue other commands while your program runs.

If the target doesn’t support async mode, GDB issues an error message if you attempt to use the background execution commands.

To specify background execution, add a & to the command. For example, the background form of the continue command is continue&, or just c&. The execution commands that accept background execution are:

run

See Starting your Program.

attach

See Debugging an Already-running Process.

step

See step.

stepi

See stepi.

next

See next.

nexti

See nexti.

continue

See continue.

finish

See finish.

until

See until.

Background execution is especially useful in conjunction with non-stop mode for debugging programs with multiple threads; see Non-Stop Mode. However, you can also use these commands in the normal all-stop mode with the restriction that you cannot issue another execution command until the previous one finishes. Examples of commands that are valid in all-stop mode while the program is running include help and info break.

You can interrupt your program while it is running in the background by using the interrupt command.

interrupt

interrupt -a

Suspend execution of the running program. In all-stop mode, interrupt stops the whole process, but in non-stop mode, it stops only the current thread. To stop the whole program in non-stop mode, use interrupt -a.

---