| Debugging with GDB: All-Stop Mode |
|---|
Next: Non-Stop Mode, Up: Thread Stops [Contents][Index]
In all-stop mode, whenever your program stops under GDB for any reason, all threads of execution stop, not just the current thread. This allows you to examine the overall state of the program, including switching between threads, without worrying that things may change underfoot.
Conversely, whenever you restart the program, all threads start
executing. This is true even when single-stepping with commands
like step or next.
In particular, GDB cannot single-step all threads in lockstep. Since thread scheduling is up to your debugging target’s operating system (not controlled by GDB), other threads may execute more than one statement while the current thread completes a single step. Moreover, in general other threads stop in the middle of a statement, rather than at a clean statement boundary, when the program stops.
You might even find your program stopped in another thread after continuing or even single-stepping. This happens whenever some other thread runs into a breakpoint, a signal, or an exception before the first thread completes whatever you requested.
Whenever GDB stops your program, due to a breakpoint or a signal, it automatically selects the thread where that breakpoint or signal happened. GDB alerts you to the context switch with a message such as ‘[Switching to Thread n]’ to identify the thread.
On some OSes, you can modify GDB’s default behavior by locking the OS scheduler to allow only a single thread to run.
set scheduler-locking mode
Set the scheduler locking mode. It applies to normal execution,
record mode, and replay mode. If it is off, then there is no
locking and any thread may run at any time. If on, then only
the current thread may run when the inferior is resumed. The
step mode optimizes for single-stepping; it prevents other
threads from preempting the current thread while you are stepping, so
that the focus of debugging does not change unexpectedly. Other
threads never get a chance to run when you step, and they are
completely free to run when you use commands like ‘continue’,
‘until’, or ‘finish’. However, unless another thread hits a
breakpoint during its timeslice, GDB does not change the
current thread away from the thread that you are debugging. The
replay mode behaves like off in record mode and like
on in replay mode.
show scheduler-locking
Display the current scheduler locking mode.
By default, when you issue one of the execution commands such as
continue, next or step, GDB allows only
threads of the current inferior to run. For example, if GDB
is attached to two inferiors, each with two threads, the
continue command resumes only the two threads of the current
inferior. This is useful, for example, when you debug a program that
forks and you want to hold the parent stopped (so that, for instance,
it doesn’t run to exit), while you debug the child. In other
situations, you may not be interested in inspecting the current state
of any of the processes GDB is attached to, and you may want
to resume them all until some breakpoint is hit. In the latter case,
you can instruct GDB to allow all threads of all the
inferiors to run with the set schedule-multiple
command.
set schedule-multiple
Set the mode for allowing threads of multiple processes to be resumed
when an execution command is issued. When on, all threads of
all processes are allowed to run. When off, only the threads
of the current process are resumed. The default is off. The
scheduler-locking mode takes precedence when set to on,
or while you are stepping and set to step.
show schedule-multiple
Display the current mode for resuming the execution of threads of multiple processes.
Next: Non-Stop Mode, Up: Thread Stops [Contents][Index]